Focused Shaft Clamp Supply
EP-SCS Aluminum Shaft Clamps for Machine Builders and MRO Buyers
Shaft-Clamp.top is focused on the EP-SCS family of single-split aluminum shaft clamps for axial positioning, guide-shaft stops and general mechanical locating duties. The range covers 6–60 mm nominal bores with model-specific d/D/B/M/W/K dimensions that buyers can compare before requesting a quotation.
Our goal is to make a standard-size, replacement or non-standard enquiry easy to define. Buyers can start from the model table, compare the machine envelope and then send the shaft, keyway and application details needed for a clear fit review.
Product Scope
The EP-SCS range includes eighteen metric bore sizes from EP-SCS06 through EP-SCS60. The collars use a single-split clamp format, and the product data identifies outside diameter, body width, clamp screw, split width and keyway dimension where applicable.
The standard collar is plain-bore, while keyway information is available for most models from 10 mm bore upward. When a buyer requires a keyed interface or a bore outside the listed range, the enquiry should include the mating shaft geometry so feasibility can be reviewed against the actual assembly.
Selection Support
Model Comparison
Use the complete EP-SCS table to compare bore, outside diameter, width, screw and keyway data before opening a model page.
Application Matching
Discuss guide-shaft stops, machine positioning, motor/drive references, automation hardware and maintenance replacement needs.
Drawing-Based RFQs
Send a drawing, photo or measured dimensions when replacement fit or surrounding clearance cannot be described by bore alone.
How We Approach Fit and Replacement
Machine interfaces are reviewed from the dimensions that actually control installation: shaft diameter, outside-diameter clearance, axial width, screw access and keyway geometry where required. This helps buyers avoid a common replacement problem in which the bore matches but the collar body conflicts with surrounding hardware.
For application-critical requirements such as tightening torque, axial holding demand, aluminum grade, surface finish or compliance documents, include the requirement in the RFQ. The quotation can then address the ordered configuration directly rather than relying on a generic assumption.
Global Enquiry Support
Enquiries are welcome from the United States, Germany, Japan, India, wider Europe, Southeast Asia and other industrial markets. Metric EP-SCS data provides a consistent basis for discussion, while drawings and measured replacement dimensions help bridge differences in local equipment and unit conventions.
Contact [email protected]. Address: 8~10 Ventura Place Dandenong South Victoria Australia 3175.